2 Pole Contactor 30 Amp 240VAC Coil Exact Fit with Relays, Air Conditioner, Heat Pump, Refrigeration Systems

2 Pole Contactor 30 Amp 240VAC Coil Exact Fit with Relays, Air Conditioner, Heat Pump, Refrigeration Systems2 Pole Contactor 30 Amp 240VAC Coil Exact Fit with Relays, Air Conditioner, Heat Pump, Refrigeration Systems Key Features Poles: 2 Pole, Single Phase Full Load Amps (FLA): 30A Resistive Load Amps (RES): 40A Coil Voltage: 240VAC, 50 60 Hz Maximum Voltage Rating: 600V Terminal Type: Screw Enclosed contacts for protection against dust and debris Replaces Cross Reference Part Numbers Can replace 2 pole contactors with ratings of 20A, 25A, and 30A. Direct

2 Pole Contactor 30 Amp 240VAC Coil Exact Fit with Relays, Air Conditioner, Heat Pump, Refrigeration Systems

Key Features

• Poles: 2 Pole, Single Phase
• Full Load Amps (FLA): 30A
• Resistive Load Amps (RES): 40A
• Coil Voltage: 240VAC, 50/60 Hz
• Maximum Voltage Rating: 600V
• Terminal Type: Screw
• Enclosed contacts for protection against dust and debris

Replaces / Cross-Reference Part Numbers

• Can replace 2-pole contactors with ratings of 20A, 25A, and 30A.
• Direct replacement for Supco DP302402.

Compatibility & Fitment

• Designed for use in residential and commercial HVAC systems.
• Applications include air conditioners, heat pumps, condenser units, and refrigeration systems.
• Fits systems requiring a 2-pole definite purpose contactor with a 30 Amp rating and 240VAC coil.

When to Replace

• Outdoor unit (condenser) fails to start or runs intermittently.
• Compressor or fan motor does not engage when the system calls for cooling or heating.
• A loud humming or chattering sound is heard from the contactor.
• Visible signs of heat damage, arcing, or pitting on the contacts.
• The unit runs continuously and will not shut off.

Installation Tips

• Disconnect all electrical power to the HVAC unit at the breaker and service disconnect before servicing.
• Use a multimeter to confirm that no voltage is present.
• Document or photograph the original wire locations before disconnecting.
• Ensure all electrical connections are clean and securely fastened to the terminals.
• Verify that the replacement contactor's specifications match the system's requirements for amperage and coil voltage.